How To Reprogram US E60 M5 SMG to Euro

You will need to download these files to flash module to euro
http://wuuwza.com/en/file/628295/e60m5-smg-reprogram.zip.html

After Installing WinKFP setup.exe restart your PC
1)Open WinKFP Tool on the top left side click Import/Export>Import>PABD choose 07gdsmg3.ipo
2)Aster importing 07gdsmg3.ipo Click Import/Export>P-SGBD and choose 10FLASH.prg
3)After importing 10flash.prg Click Import/Export>Assambly Line Data and choose GDSMG3 folder
(not folder contents but the folder itself) and click import
4)Now copy contents of gdaten folder to the NFS folder browse to your
NFS folder (usually C:\EC-APPS\NFS\ or just C:\NFS\ depending on your installation If there are files already in this
directory, overwrite them with the files you copied.
Now your WinKFP Tool is Ready for Programming Gearbox (FLASHING MODULE)

I recommend using this bmw inpa k+dcan cable.
http://www.obd365.com/wholesale/bmw-inpa-k-can-743.html

BUT THERE IS STILL A RISK TO BRICK MODULE WITH D-CAN CABLES THIS ONE THAT IS MADE FOR GERMANY IS ONLY LITTLE BIT SAFER

Ensure the port numbers are the same in the obd.ini file in 'C:\EDIABAS\Bin' folder and in device manager;
In device manger where your cable is plugged into it will be "COMx" x= 1,2,3,4, etc. right click it, properties, advanced, and then set latency to 1 ms. it will come standard at 16ms.

Hook up your car to the power supply and turn it on. Put the key in position 2.
a. Try to keep the voltage between 13-14V. If it goes below 12.5V or above 14.5V,
the flashing process could fail and result in a bricked module. Start WinKFP and click “Comfort Mode”.
Click “choose ZUSB Scroll down to gdsmg3 click gdsmg3 and choose 7842206 click Ok then enter VIN
by clicking (enter VIN) and click done and then Press program. WinKFP will give you a message
about having X number of flashes available – hit okay to that prompt After the flash gets to 100%
you will get another prompt as if the flash is restarting – accept that prompt again. It will look like the flash is starting over, 

but this time it’ll go much faster. After this one completes your flash will be done.
Turn off the car. Wait about 5 minutes, put it in position 2 again. Using DIS or INPA clear any codes that may be stored in any modules.

Turn off and wait a few minutes again if necessary (if the transmission error light is still on)
Start the car and enjoy your improved shifts! You may need to run the SMG adaption procedures
THANKS TO VODYK CARTEK nightkrawler and krisboss.

www.obd365.com