How to solve BMW E-sys Read FA Failed Error

Here’s the expert solution to cannot access E-sys BMW F-series coding software read FA failed problem.

If you are new to coding, here are a few mistable you make.
The most common mistake is network configuration.

The following message is displayed when connection is not possible due to improper setting.

Read FA failed! Possibly there is no FA Stored in the VCM (C060)
negative response error:
code: the result contains an error
description: Service RDBI_FA has error in result: (Severity=2051) (Error Code=53311)
ErrorCodeDescription=module offline (Vendor code= 20039) (VendorCodeDesction=link is no longer active)
ECU:VCM_ETHERNET

If you read it all the time, you can see that there is no link module.
That is why they did not connect.
The first thing to check when connecting is IP allocation.
Lock at the lower right clock.

Are you seeing this computer now?
Of course, those who hold a wireless AP with a router do no apply.
Those who are experiencing the above problems cannot use the wireless AP.

Is not there an X on that computer?
If X is displayed, the computer and the car are not connected.
Could be a bad cable.
(The exclam ation point on the computer is normal)

Or it maybe fixed allcation, not IP auto allcation.
Please follow the steps below.

Right-click the computer’s appearance in the photo above and click Open Network and Sharing Center.

Next, click Change adapter settings.

Right-click your wired network card and click Properties.

In Local Area Connection Properties, select TCP/IPv4 and click Properties

Then select Obtain and IP address automatically and Obtain DNS server address automatically and click OK to close all the windows you just opened and working.

If this does not work, then turn off the firewall!
From the Start menu, select Control Panel.

Select Windows Firewall.
If you do not see any of them, you can change the view criteria to a big icon or a small icon

Click on Windows Firewall on the left or off

And turn off all firewalls. (BMW ENET cable for F-series coding.)

If you are using a company or a public computer and you disable firewall,
If you can not turn off the firewall, you need to set the inbound settings seperately in
Advanced Settings.
It’s too difficult to explain this.

If you do not allow the program to be selected as an inbound rule,
You have to open the port number on the wire shark,
This should not be happening.

Do not code it on your company’s computer.

But if it is the same.
So you did not read my blog.
You shoud have pressed Connect as below.
Then no, no, no

You should see if your VIN number is on the Via Connection as VIN and select that option to connect.
If you see No ZGW Available as shown in the picture below, press reflash.

Hope it helps.

Note: The document was translated from Korean.

www.obdii365.com