How to Connect Super ICOM Pro N3+ via USB and WiFi?

Super ICOM Pro N3+ diagnostic tool supports USB and WiFi connection.

How to connect Super ICOM Pro N3+ via USB?

First time use the device requires to set up IP address. 

1. Connect N3+ with power supply or power by OBD from car

2. Connect N3+ with laptop with USB

3. Go to Network Connection, find out Realtek USB FE Family Controller network

4. Click on Properties-TCP/IPV4

Set 

IP address to 169.254.90.90, 

Subnet mask: 255.255.0.0, 

Preferred DNS: 169.254.255.1, click “OK”

 

Note: Each N3+ is bound to 1 PC. If change another N3+, need to reset IP.  After disconnecting the USB cable, the network icon will disappear, and you don’t need to set the IP address again when you use the N3+ after the computer is wired or wirelessly connected to the Internet.

Then run ITool Radar, you will see ICOM device is connected.

How to connect Super ICOM Pro N3+ via WiFi?

N3+ supports WiFi direct connection which is very easy. You have to disconnect USB cable before connecting with WiFi. 

Search for WiFi name "N3+ ICOM-****" and pair with password 12345689.